Laying Guide

Blog Image

1.Wall Requirement

Follow up with a detergent, like tri-sodium phosphate (TSP). Make sure the area is well ventilated when you use this strong chemical cleaner..

Blog Image

2. Tile Preparation

Mix the tiles with different cartons which help in fine blending of shades. Ample lighting should be provided. Each bo should be spread and mixed on the floor to check for any variation mixing of tiles brings harmony to shade by avoiding obvious patches...

Blog Image

3.Tiles Laying

Apply a high-quality ceramic adhesive on the wall anyplace the first tiles on the corner.Apply even pressure on the four corners of tiles to ensure adhesion of tiles to substrate.Cover the Area of the wall that can be done without cutting tiles.

Blog Image

4.Applying Grout

After 24 Hours Of Laying of tiles, the grouting is done. Always use good quality grout. Apply the grout diagonally between the tiles using a sponge to fill the gaps between the tiles, Fill the joints with grouts as directed by Grout manufactures...

Blog Image

5.Curve Cutting .

To fill the around the curve surface of wash basin, etc. measure and mark the curve on cardboard and place te cardboard on the tile to cut it..

Blog Image

6.Round Cutting

To pass a pipe through the tile. The tile has to be cut in a specific manner. Mark it's position on the tile. Draw a straight line passing through the center of the circle. Cut the tile on the line drawn. Cut the semi-circle on each of the half. These two halves placed together.

Blog Image

7. Window Recess Tilling

Tile has be cut in "L" shape for window recess. Cut a line from center to edge and then draw a right-angle line vertically down. Cut the tile to get an "L" shape that can fit a window recess...

Blog Image

8. Accessory Tilesw Fitting

While Laying the normal tiles. Keep an empty space where accessory tiles will fit. Apply the adhesive on the back of accessory tile and then place it uniformly in the space and apply even pressure to place the accessory tile...